Product ID:G-3726 THERMELEC INSULATING VARNISH
MSDS Date:07/31/1986
FSC:5970
NIIN:00-161-7232
MSDS Number: BJRLH

BALL CHEMICAL CO

1114 WM FLINN HWY
GLENSHAW, PA 15116-2638
US

Emergency Phone: 412-486-1111

Info Phone: 412-486-1111

Preparer: JOHN C.FUNK

Cage: 51747

RANBAR TECHNOLOGY INC

GLENSHAW, PA 15116 US

Telephone: 800-424-9300 (CHEMTREC)

Cage: 0TS14

PETROLEUM DISTILLATE, MINERAL SPIRITS, (NAPHTHA, MEDIUM

CAS: 64742-88-7

Fraction By Weight: 50%

ALKYD PHENOLIC RESIN

CAS: 71965-36-1

Fraction By Weight: 48%

XYLENES (O-,M-,P- ISOMERS) (SARA III)

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 2%

OSHA PEL 100 PPM/150 STEL

ACGIH TLV: 100 PPM/150STEL;9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:IRRITATION OF EYES AND MUCOUS
MEMBRANES, CHEMICAL PNEUMONITTA, PULMONARY EDEMA/HEMORRHAGE, AND
DEPRESSION OF CENTRAL NERVOUS SYSTEM.
Effects of Overexposure:EYE IRRITATION, IRRITAION OF MUCOUS MEMBRANES,
DRY SKIN, HEADACHE, DIZZINESS, NAUSEA, OR LOSS OF CONXCIOUSNESS.
Medical Cond Aggravated by Exposure:PERSONS WITH EXISTING EYE, SKIN,
AND RESPIRATORY DISORDERS MAY BE AT INCREASED RISK FROM EXPOSURE TO
THIS PRODUCT.

First Aid:EYES: FLUSH WITH LARGE AMOUNTS OF WATER. IF IRRITATION
PERSISTS GET MEDICAL ATTENTION. SKIN: REMOVE CONTAMINATED CLOTHING.
WASH AREA WITH SOAP AND WATER. GET MEDICAL ATTENTION IF IRRITATION
DEVELOPS. INHALATION: MOVE TO FRESH AIR. IF NOT BREATHING GIVE
CPR. IF BREATHING DIFFICULT GIVE OXYGEN. GET MEDICAL ATTENTION.
INGESTION: DO NOT INDUCE VOMITING. GET MEDICAL ATTENTION.

Flash Point Method:SCC
Flash Point:104F,40C
Lower Limits:1.0
Upper Limits:7.0
Extinguishing Media:FOAM, CARBON DIOXIDE, OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR SCBA WITH A FULL FACEIECE OPERATED IN
PRESSURE-DEMAND MODE WHEN FIGHTING FIRES. USE WATER TO COOL FIRE
EXPOSED CONTAINERS, EQUIPMENT, OR STRUCTURES.
Unusual Fire/Explosion Hazard:A DIRECT WATER STREAM MAY SPREAD BURNING
PRODUCT. VAPORS ARE HEAVIER THAN AIR AND MAY TRAVEL ALONG GROUND TO
DISTANT IGNITION SOURCE AND BACKFLASH.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. WEAR PROPER
PROTECTION EQUIPMENT. VENTILATE THE AREA. PREVENT RUN-OFF INTO
SEWERS, STREAMS, OR OTHER BODIES OF WATER. ABSORB IN INERT MATERIAL
AND PLACE IN APPROPIATE D ISPOSAL CONTAINERS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN TIGHTLY CLOSED CONTAINERS
AWAY FROM HEAT, SPARKS, AND OPEN FLAME. CONTAINERS SHOULD BE
GROUNDED WHEN TRANSFERRING.
Other Precautions:NEVER USE PRESSURE TO EMPTY. LOOSEN CLOSURES
CAREFULLY. EMPTY CONTAINERS MAY CONTAIN HAZARDOUS RESIDUES. NEVER
USE WELDING OR CUTTING TORCHES ON OR NEAR CONTAINERS (EVEN EMPTY)
BECAUSE PRODUCT (OR RES IDUE) CAN IGNITE EXPLOSIVELY.

Respiratory Protection:IF THE TLV OF ANY COMPONENT IS EXCEEDED, A
NIOSH/MSHA APPROVED AIR SUPPLIED RESPIRATOR IS ADVISED IN ABSENCE
OF PROPER ENVIRONMENTAL CONTROLS.
Ventilation:PROVIDE SUFFICIENT VENTILATION (EXPLOSION PROOF) TO
MAINTAIN EXPOSURE BELOW THE TLV.
Protective Gloves:SOLVENT RESISTANT TPE SUCH AS NITRILE.
Eye Protection:CHEMICAL SPLASH GOGGLES ARE ADVISED.
Other Protective Equipment:EYE WASH STATION AND SAFETY SHOWER.
IMPERVIOUS CLOTHING AND BOOTS IF NEEDED TO PREVENT SKIN CONTACT.
Work Hygienic Practices:WASH AFTER HANDLING AND BEFORE EATING,
DRINKING, OR SMOKING. LAUNDER CONTAMINATED CLOTHING BEFORE REUSE.
Supplemental Safety and Health
DO NOT WEAR CONTACT LENSES. EMPTY CONTAINERS MAY CONTAIN HAZARDOUS
PRODUCT RESIDUES AND CONSTITUTE HAZARDOUS WASTE. DISPOSE OF EMPTY
CONTAINERS IN COMPLIANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.

HCC:F4
Boiling Pt:=157.2C, 315.F
Vapor Pres:2
Vapor Density:>1, AIR=1
Spec Gravity:0.89
Evaporation Rate & Reference:0.7 (ETHYL ETHER=1)
Solubility in Water:INSOLUBLE
Appearance and Odor:AMBER LIQUID. PETROLEUM DISTILLATE ODOR.

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HIGH HEAT, OPEN FLAMES AND SOURCES OF
IGNITION.
Hazardous Decomposition Products:BURNING MAY PRODUCE CARBON MONOXIDE
AND CARBON DIOXIDE.
Conditions to Avoid Polymerization:WILL NOT OCCUR.

Waste Disposal Methods:DISPOSE OF WASTE IN ACCORDANCE WITH LOCAL, STATE
AND FEDERAL REGULATIONS. MANUFACTURER RECOMMENDS DISPOSING BY
INCINERATION IF PERMITTED.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.